Lab 1: An npn-based Inverting Amplifier

• Requirements:
•   Use a npn BJT
•   40 db midband gain
•   Inverting gain
•   Must allow frequencies from 200 Hz to 200k Hz
•   Drive a 100k Ohm load
•   Use ±5 Volt power supply rails

Lab 2 : Multi-stage Amplifier (open-loop)

• Requirements:
•   34 db midband gain
•   Inverting gain
•   Must allow frequencies from 50 Hz to 500k Hz
•   Drive a 100 Ohm load
•   Use ±15 Volt power supply rails
•   Use less than 30 milliAmp current from supply

Lab 3 : Voltage Feedback Amplifier

• Requirements:
•   20 db midband gain
•   Non-inverting gain
•   Negative Feedback
•   Voltage Sampling
•   Voltage Mixing
•   Must allow frequencies from 100 Hz to 1 MHz
•   Drive a 50 Ohm load
•   Use ±15 Volt power supply rails
•   Use less than 10 milliAmp current from supply

Lab 4 : Current Feedback Amplifier

• Requirements:
•   20 db midband gain
•   Inverting gain
•   Negative Feedback
•   Voltage Sampling
•   Current Mixing
•   Must allow frequencies from 100 Hz to 5 MHz
•   Drive a 50 Ohm load
•   Use ±15 Volt power supply rails
•   Use less than 15 milliAmp current from supply